Pierre,
This is the old list. I didn't realize when I answered your last one
that we were on the old list.
If you aren't subscribed to the new list, send a message to:
[log in to unmask]
The moderator will approve your first post, then all will be good.
There are guys on the new list who use accessible digipan more than me
and can be more help.
Below are the menus for the 590s, followed by the menus for the 590sg,
tnx to Jim KE5AL.
73, Steve KW3A
00, "Display brightness",
01, "Display backlight color",
02, "Panel key response for double function",
03, "Beep output level",
04, "Sidetone volume",
05, "VGS-1 message playback volume",
06, "VGS-1 Voice Guide announcement volume",
07, "VGS-1 announcement speed",
08, "VGS-1 announcement language",
09, "VGS-1 auto announcement",
10, "MHz step",
11, "Tuning control adjustment rate",
12, "Rounds off VFO frequencies changed by using the MULTI/CH
control",
13, "9 kHz frequency step size for the MULTI/CH control in AM
mode",
14, "Frequency step size for the MULTI/CH control in SSB/ CW/
FSK mode",
15, "Frequency step size for the MULTI/CH control in AM mode",
16, "Frequency step size for the MULTI/CH control in FM mode",
17, "Number of quick memory channels",
18, "Tunable memory recall frequencies",
19, "Program scan partially slowed",
20, "Slow down frequency range for the program scan",
21, "Program scan hold",
22, "Scan resume method",
23, "Auto mode operation",
24, "Auto notch tracking speed",
25, "TX filter for SSB/AM low cut",
26, "TX filter for SSB/AM high cut",
27, "TX filter for SSB-DATA low cut",
28, "TX filter for SSB-DATA high cut",
29, "Speech processor effect",
30, "DSP TX equalizer",
31, "DSP RX equalizer",
32, "Electric keyer mode",
33, "Keying priority over playback",
34, "CW RX pitch/ TX sidetone frequency",
35, "CW rise time",
36, "CW keying dot, dash weight ratio",
37, "Reverse CW keying auto weight ratio",
38, "Bug key function",
39, "Reversed dot and dash keying",
40, "MIC UP/DWN key paddle function",
41, "Auto CW TX when keying in SSB",
42, "Frequency correction for changing SSB to CW",
43, "No Break-in operation while adjusting keying speed",
44, "FSK shift",
45, "FSK keying polarity",
46, "FSK tone frequency",
47, "MIC gain for FM",
48, "Fine transmission power tuning",
49, "Time-out timer in minutes",
50, "Xverter/ power down of Xverter",
51, "TX hold when AT completes the tuning",
52, "In-line AT while receiving",
53, "Linear amplifier control relay for HF band",
54, "Linear amplifier control relay for 50 MHz band",
55, "Constant recording",
56, "Repeat the playback",
57, "Interval time for repeating the playback (in seconds)",
58, "Split frequency transfer in master/ slave operation",
59, "Permit to write the transferred Split frequencies to the
target VFOs",
60, "TX inhibit",
61, "COM port communication speed",
62, "USB port communication speed",
63, "Audio input line selection for data communications",
64, "Audio level of USB input for DATA communications",
65, "Audio level of USB output for DATA communications",
66, "Audio level of ACC2 input for data communications",
67, "AUDIO level of ACC2 output for data communications",
68, "Mixing beep tones for ACC2/USB audio output",
69, "Data VOX",
70, "Data VOX delay time",
71, "Data VOX gain for the USB audio input",
72, "Data VOX gain for the ACC2 terminal",
73, "PKS polarity",
74, "Busy lockout (TX)",
75, "CTCSS mute control",
76, "PSQ control signal logic",
77, "PSQ source output condition",
78, "Auto Power Off (in minutes)",
79, "Front panel PF A key assignment",
80, "Front panel PF-key assignment",
81, "Microphone PF 1 key assignment",
82, "Microphone PF 2 key assignment",
83, "Microphone PF 3 key assignment",
84, "Microphone PF 4 key assignment",
85, "Microphone DWN key assignment",
86, "Microphone UP key assignment",
87, "Power on message",
00, "Version information",
01, "Power on message",
02, "Display brightness",
03, "Display backlight color",
04, "Panel key response for double function",
05, "Beep output level",
06, "Sidetone volume",
07, "VGS-1 message playback volume",
08, "VGS-1 Voice Guide announcement volume",
09, "VGS-1 announcement speed",
10, "VGS-1 announcement language",
11, "VGS-1 auto announcement",
12, "MHz step",
13, "Tuning control adjustment rate",
14, "Rounds off VFO frequencies changed by using the MULTI/CH
control",
15, "9 kHz frequency step size for the MULTI/CH control in AM
mode",
16, "Frequency step size for the MULTI/CH control in SSB mode",
17, "Frequency step size for the MULTI/CH control in CW/ FSK
mode",
18, "Frequency step size for the MULTI/CH control in AM mode",
19, "Frequency step size for the MULTI/CH control in FM mode",
20, "RX frequency during split transmission",
21, "Number of quick memory channels",
22, "TUNABLE MEMORY RECALL FREQUENCIES",
//18, "Tunable memory recall frequencies",
23, "Program scan slow down",
24, "Slow down frequency range for the program scan",
25, "Program scan hold",
26, "Scan resume method",
27, "Auto mode change",
28, "High Cut/Low Cut and Width/Shift change (SSB)",
29, "High Cut/Low Cut and Width/Shift change (SSB Data)",
30, "Auto notch tracking speed",
31, "TX filter for SSB/AM low cut",
32, "TX filter for SSB/AM high cut",
33, "TX filter for SSB-DATA low cut",
34, "TX filter for SSB-DATA high cut",
35, "Speech processor effect",
36, "transmit equalizer",
37, "Receive equalizer",
38, "Electric keyer mode",
39, "KEYING PRIORITY OVER PLAYBACK",
40, "CW RX pitch/ TX sidetone frequency",
41, "CW rise time (ms)",
42, "CW keying dot, dash weight ratio",
43, "Reverse CW keying auto weight ratio",
44, "Bug key function",
45, "Reversed dot and dash keying",
46, "MIC paddle function",
47, "Auto CW TX when keying in SSB",
48, "Frequency correction for changing SSB to CW",
49, "No Break-in operation while adjusting keying speed",
50, "FSK shift",
51, "FSK keying polarity",
52, "FSK tone frequency",
53, "MIC gain for FM",
54, "Fine transmission power tuning",
55, "Time-out timer in minutes",
56, "Xverter/ power down of Xverter", // ?
57, "TX hold when AT completes the tuning",
58, "AT operation while receiving",
59, "Linear amplifier control relay for HF band", // ?
60, "Linear amplifier control relay for 50 MHz band", // ?
61, "Constant recording",
62, "Voice/message playback repeat",
63, "Interval time for repeating the playback (in seconds)",
64, "Split frequency transfer in master/ slave operation",
65, "write the transferred Split frequencies to the target
VFOs",
66, "Transmit inhibit",
67, "COM port communication speed",
68, "USB port communication speed",
69, "DATA modulation line",
70, "Audio source of SEND/PTT transmission for data mode",
71, "Audio level of USB input for DATA communications",
72, "Audio level of USB output for DATA communications",
73, "Audio level of ACC2 input for data communications",
74, "AUDIO level of ACC2 output for data communications",
68, "Mixing beep tones for ACC2/USB audio output",
76, "Data VOX",
77, "Data VOX delay time",
78, "Data VOX gain for the USB audio input",
79, "Data VOX gain for the ACC2 terminal",
80, "PKS polarity change",
81, "Busy transmit inhibit",
82, "CTCSS mute control",
83, "PSQ control signal logic",
84, "PSQ source output condition",
85, "DRV connector output function",
86, "APO function (minutes)",
87, "Front panel PF A key assignment",
88, "Front panel PF-key assignment",
89, "RIT key assignment",
90, "XIT key assignment",
91, "CL key assignment",
92, "Front panel MULTI/CH key assignment (exclude CW mode)",
93, "Front panel MULTI/CH key assignment (CW mode)",
94, "Microphone PF 1 key assignment",
95, "Microphone PF 2 key assignment",
96, "Microphone PF 3 key assignment",
97, "Microphone PF 4 key assignment",
98, "Microphone DWN key assignment",
99, "Microphone UP key assignment",
_______________________________________________
Blind-hams mailing list
[log in to unmask]
http://lists.porkcast.net/listinfo.cgi/blind-hams-porkcast.net
On 5/7/2018 8:06 PM, Pierre Berube wrote:
>
>
> Hi all, I hope someone can help me on this too.
>
>
>
> Pierre K9EYE here
>
> I must be really confused, and please forgive me if this sounds stupid.
>
> I downloaded Digipan, and the scrips for the Digipan for my jaws.
>
> This is my problem?
>
> Also I have a ts590 SG not a ts 590S, the menus are totally different that
> is what is confusing me.
>
> That comes with the notes.
>
> I just cannot seem to get my ALC down.
>
> Seems that I am over driving the radio .
>
> If anyone has some cool advise that would be nice.
>
> I am using my ts590SG, with my Dell 64 bit laptop, with Jaws 15 with an
> operating system 15.
>
> I Thank you in advance,
>
> Pierre Berube K9EYE Crystal Lake, IL EN52UF
>
> I thought I posted to the correct blind ham list but never got an answer,
> Hopefully this is the correct list.
>
>
>
>
>
>
>
>
>
>
>
> -----Original Message-----
>
> From: [log in to unmask] [mailto:[log in to unmask]]
>
> Sent: Friday, April 20, 2018 4:01
>
|
